QX60 FWD

26 service bulletins filed with NHTSA for this model year

• May 1, 2026SERVICE BRAKESITB26-005

  AEB WARNING WITH ONE OR MORE CURRENT DTCS STORED IN THE ADAS CONTROL UNIT 2, AND/OR THE LASER/RADAR CONTROL UNIT IF YOU CONFIRM The front radar is inoperative, the AEB warning is displayed, and one or more of the following DTCs are stored as CURRENT: · U2752-88 for “Ethernet circuit” stored in the ADAS control unit 2, · U275F-88 for “Ethernet circuit” stored in the LASER/RADAR (DISTANCE SENSOR) control unit, OR · C2589-86 for “TCM” stored in the LASER/RADAR (DISTANCE SENSOR) control unit, AND/OR

• May 1, 2026FUEL/PROPULSION SYSTEMITB26-002A

  FUEL FILLER TUBE LOWER SEAL IS LEAKING AND DTC P0456 IS STORED IN THE ECM This bulletin is no longer active. Please discard previous versions of ITB26-002.

• Apr 13, 2026STRUCTURE:BODYITB09-063C

  CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Infiniti by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is

• Mar 31, 2026STRUCTURE:BODYITB26-004

  FRONT FASCIA POPPING OUT NEAR HEADLAMP IF YOU CONFIRM The Front Bumper Fascia is detaching from the fender under the headlamp on one/or both sides. ACTION Refer to the SERVICE PROCEDURE in this bulletin to: 1. Remove the Front Bumper Fascia. 2. Replace the affected Headlamp Bracket. 3. Replace the affected Front Bumper Fascia Side Bracket. 4. Reinstall the Front Bumper Fascia, with Betaseal (or equivalent) adhesive between the Front Bumper Fascia and the affected side Front Bumper Fascia Side Br

• Feb 2, 2026FUEL/PROPULSION SYSTEMITB26-002

  FUEL FILLER TUBE LOWER SEAL IS LEAKING AND DTC P0456 IS STORED IN THE ECM IF YOU CONFIRM The vehicle has a visible leak with a smoke machine test coming from the fuel filler tube lower seal, AND DTC P0456 is stored as “Active”, “Past”, or “Pending” in the ECM. ACTION 1. Remove the supplied funnel from the rear of the vehicle or trunk. 2. Insert the funnel completely in the fuel filler tube and remove completely five (5) times. 3. Re-check the fuel filler tube lower seal with a smoke machine to d

• May 29, 2025STRUCTURE:BODYITB25-008

  EXCESS DUST ENTERING CABIN WHILE DRIVING ON DIRT ROADS IF YOU CONFIRM That while driving on dirt roads with all doors and windows closed, that there is excessive dust intrusion into the vehicle’s cabin that is settling on the inside of the doors. ACTION Refer to the SERVICE PROCEDURE in the bulletin to: 1. Install Butyl Patches around the door seals of driver (LH) side and passenger (RH) side front and rear doors. 2. Install drain plugs into door drains of driver (LH) side and passenger (RH) sid

• Mar 19, 2025UNKNOWN OR OTHERITB25-005

  AIR CONDITIONING IS INOPERATIVE WITH LEAK FROM HIGH/LOW SIDE PIPE JUNCTION IF YOU CONFIRM The client states that the A/C is not blowing cold or is blowing warm on driver’s side vents, AND Leak detection dye is confirmed as present on the high-pressure and low-pressure A/C pipe junction blocks. HINT: See Refrigerant Leak Examples on page 2. ACTION Replace the A/C High-Pressure and Low-Pressure Pipe. · Refer to the ESM: VENTILATION, HEATER & AIR CONDITIONER > HEATER & AIR CONDITIONING SYSTEM > REM

• Feb 25, 2025ELECTRICAL SYSTEMITB25-002

  DRIVABILITY CONCERNS AT HIGHWAY SPEEDS AND ON INCLINES IF YOU CONFIRM A lugging / shutter / judder at highway speeds, especially on slight inclines, ACTION Reprogram the Electronic Control Module (ECM). IMPORTANT:

• and 18 more

Source: NHTSA manufacturer communications (technical service bulletins).